Jung compli 300 E sewage lifting unit

JUNG PUMPEN Fäkalienhebeanlage compli 300 E

The submersible single-pump system consists of

• Plastic (PE) containers in a stepped form with an optimized floor to reduce deposits and blockages,
• A cast iron base plate with an integrated ring casing,
• mounted motor, non-return valve and pressure outlet.
• Tank > dimensions: 445 x 605 x 540 mm (HxWxD) >
• Container volume: 50 l >
• > Nozzle for ventilation pipe DN 70 with sleeve, optionally as sleeve in DN 50 >
• 4 inlets DN 100/50 on three sides and above.
• Version as sleeve with clamping flange and insertion stop.
• Inlet height on the sides: 180 mm >
• Additional connection 50 mm vertical as a sleeve for e.g. a diaphragm hand pump. >
• Additional connection 50 mm horizontal as sleeve >
• Connection flange DN 80 >
• Flexible connection with 2 hose clamps for pressure pipe with external diameter 90 mm
• Vertical submersible pump for pumping sewage in accordance with DIN 1986-3,
• mounted on the container ready for operation,
• Vortex impeller with large free passage,
• dry-running safe due to permanent grease filling,
• Motor thermostat to protect against overheating,
• Cable entry sealed to be waterproof and exchangeable through plug connection.
• Free passage: 50 mm Flow rate Q: 33-13 cbm/h
• Conveying height H: 1-9 m Motor protection type: IP 68 Voltage: 1/N/PEx230
• Motor power P2: 0.95 kW Motor speed n: 2725 rpm Operating mode: S3 according to VDE
• Outlet flange: DN 80
• Weight: 31 kg
• Control > Automatic and water-level dependent switching on and off >
• Level detection built into the container. >
• Plug housing, 121x66x55 mm (HxWxD), protection class IP 44,
• 4m cable,
• LED display "ready for operation"
• Manual-0-automatic switch
• Mains-dependent alarm buzzer
• Potential-free collective fault signal contact