SANIT Fauch 610 special cleaning agent for gas appliances

SANIT Fauch 610

Characteristics:

• with regular and frequent application, the laborious removal of the heat exchanger is no longer necessary in many cases. This makes cleaning with Fauch 610 particularly time and cost effective
• was specially developed for cleaning gas-fired instantaneous water heaters
• is an aerosol developed from Fauch 600
• consists of a mixture of physical and chemical components. Special surfactants enable the active ingredients to penetrate the deposits. The salts contained in the solution, which are easily decomposed by heat, penetrate into the deposits. When the system is heated up, the deposits are loosened by the propellant effect and lifted off the substrate. In gas flow heaters, the detached deposits are carried away through the chimney
• In the case of gas deposits, the deposits fall off and can be removed
• The salts contained in Flue 610 decompose without leaving any residue. No residues of the cleaning product remain on the surface.

Use:

• Shake well before use. Carefully insert the spray wand (separate article 8702) into the spray cap. Put the equipment into operation as usual. Guide the spray tube from below over the flames and spray the lamella block with short squirts. To avoid damaging the spray tube, it is recommended to remove it from the flame area immediately after each spraying process. Repeat the spraying process as needed. If necessary, the lamellae can also be sprayed from above by turning the spray tube 180°. When the spraying process is complete, a small amount of Fauch 610 will come out of the spray tube until the pressure in the spray tube has been released. It is advisable to have a cloth ready to catch the drops.